What is the water temp in Jandy aquapure boost mode?
Temperature of Pool is < 50ºF (10°C). Chlorine production stopped. In “Boost” mode unit will operate at 100% production for 24 run time hours. Input has exceeded Maximum Range. AquaLink RS is controlling the AquaPure and desired output percentages.
Where to get help with aquapure error codes?
If you need more help understanding the AquaPure Error Codes, or need help fixing the issue, stop by a local Leslie’s Pool Supplies store and speak with a trained pool professional today. You can also request pool equipment and repair services by contacting our Pool Service and Repair Department HERE.
How to change the salinity reading on aquapure?
•Press and release the “Temperature “ button within 5 seconds to enter the salinity calibration screen. •The system will display the salinity reading, press the up arrow to increase the reading and the down arrow to decrease the reading. •When the proper reading is reached press the “Temperature” button within 5 seconds to store it in memory. 15
Why is the flow light not working on my Jandy aquapure?
There is a button on the daughter board that you push to reset the sensor. Actually it is supposed to re-calibrate the salinity sensor. Once the unit comes on line, about 4 min, push and hold that button till the flow light on the board comes back on. OK so it is working now!
•Press and release the “Temperature “ button within 5 seconds to enter the salinity calibration screen. •The system will display the salinity reading, press the up arrow to increase the reading and the down arrow to decrease the reading. •When the proper reading is reached press the “Temperature” button within 5 seconds to store it in memory. 15
What do I need to know about Jandy aquapure?
1. Flow/ Salinity sensor indicates water temperature at sensor above 108 F. Reduce your water temperature. 2. Troubleshoot with Jandy or a licensed professional. 1. Verify proper flow/temp/salinity sensor was installed properly. 2. Check salinity. Add if necessary.
If you need more help understanding the AquaPure Error Codes, or need help fixing the issue, stop by a local Leslie’s Pool Supplies store and speak with a trained pool professional today. You can also request pool equipment and repair services by contacting our Pool Service and Repair Department HERE.
What is the low input voltage code on Jandy aquapure?
(Generates 173 – Low input voltage code if Level 2 code 188 is present) (Generates 170 code if 188 is not present) Contact a pool professional. VAC input voltage is too low. (Generates 173 code if Level II code 187 is present) Contact a pool professional.
