Where is pool pump drain plug?
plug without an o-ring. Pool pumps usually have two pump drain plugs, one in the front, at the base of the hair & lint strainer or pump pot, and another plug further back towards the motor, to drain the volute, or impeller housing.
How do I drain my pool pump and filter?
Shut off the pump. Go to the back of the filter and unscrew the drain plug. Turn the pump back on and let the water run until it reaches the point where you want to drain the water out. Turn the pump back off and put the plug back into the drain plug.
Where is the main drain in an inground pool?
An inground swimming pool’s main drain is located in the deep end of the pool. A main drain circulates the pool’s water by pulling water off the bottom of the pool and sending it to the filter. During winter months or periods of non-use, most pool drains do not need to be plugged,…
When do I need to plug my Pool Drain?
During winter months or periods of non-use, most pool drains do not need to be plugged, but in some cases plugging a main drain is required or recommended. Plugging a main drain shuts off the suction caused by the drain and prevents water from traveling through the lines connected to the drain.
Where do you plug in a water filter?
Locate the small hole at the bottom of the main drain. This is the plumbing line to the filter. Plug the small hole with an expandable rubber plug or a plastic threaded plug, if the hole is threaded. Replace the main drain lid if needed.
Where does the water come from in a pool pump?
Water is drawn in from the pools outlets into the front of the pump, through the hair/lint trap, through the pumping chamber and out the top of the pool pump on its way to the filter. Two important things with pool pumps.
Where do you put the drain plugs on a swimming pool?
NOTE: Many swimming pool companies put the drain plugs for all the equipment items in the pump basket. Use your air compressor or a shop vacuum to blow out the lines if possible and plug them. This is a two person job. Disconnect the drain plugs on your pump and put them in the pump basket.
Where to drain above ground salt water pool?
Above ground pools should be drained a few inches below the skimmer. Inground pools with mesh covers will need to be about 12″ below the skimmer (to allow for rain and snow melt), and those with solid winter covers should be about 6″ below the skimmer.
What is a main drain in an inground pool?
An inground swimming pool’s main drain is located in the deep end of the pool. A main drain circulates the pool’s water by pulling water off the bottom of the pool and sending it to the filter. During winter months or periods of non-use, most pool drains do not need to be plugged, but in some cases plugging a main drain is required or recommended.
How do you disconnect an inground pool pump?
This is a two person job. Disconnect the drain plugs on your pump and put them in the pump basket. If your pump has unions you can completely disconnect it from the plumbing and turn it up-side down to get any remaining water out of it. Pull the drain plugs on the front and back “headers”. Not all heaters have multiple drain plugs.
