Where is the motherboard on a hot tub?
Most modern spas have circuit boards located inside the equipment area, commonly referred to as the “spa pack”. The spa pack is essentially the brain of your spa. If you find you need to replace the circuit board, it is very important to make sure you replace it with the correct board.
Where does Sundance Spas make their hot tubs?
They are based out of California, and their products are sold in more than 60 countries. Sundance® Spas focuses on creating acrylic spas, and they are rated as the top worldwide distributor and manufacturer of this particular style. They also produce in-ground and portable hot tub models.
How can I tell if my Sundance Spa is having problems?
The only way to test this is to make sure there is no loose debris in the spa, then pull the filter out and see if the flow error goes away, if it does, it is the filter. 2. Defective Circ Pump or Flow Switch: Need to check for Circ Pump operation. Is there voltage going to pump, Is there adequate Flow coming out of Heater Port in Spa?
Do you need a cover guy for a Sundance spa?
If you are needing a replacement hot tub cover for your Sundance® Spa The Cover Guy is your answer. With all Sundance® Models on file The Cover Guy can easily provide you with a new hot tub cover without you having to measure.
What kind of circulation pump does Sundance Spa use?
Note: This test only works on 850 Series with Circulation Pump prior to 2001: Try turning the #1 pump which is 2 speed.
How big are the control panels at Sundance spa?
Sundance Spa Control Panel 6600-038 SMT System 2 Pump 6600-038 or SUN6600-038 Control panel is about 10 1/8 inches wide and 3 1/8 inches high. shows 6 buttons including Temp up, Temp down, jets 1, jets2, light and mode. Sundance Spa 2 Pump SMT System… Sundance Spa control panel SUN6600-425 as used in 880 Series spas (2013-2014).
They are based out of California, and their products are sold in more than 60 countries. Sundance® Spas focuses on creating acrylic spas, and they are rated as the top worldwide distributor and manufacturer of this particular style. They also produce in-ground and portable hot tub models.
What happens when Sundance spa goes into watchdog?
When the spa goes into the Watchdog the spa will not operate. This is how it happens: When you try to use the spa, you will see 3 or 4 dashes on the control panel (depends upon the model). If you try and reset your breaker, sometimes it comes on but it will probably go back into Watchdog error – – – -.
What to do if your Sundance spa has a PF error?
Should the power return to normal, the PF error will reset itself. If the error returns, contact your Sundance Spa dealer or a qualified service technician. Communication between control panel and/or remove control panel and circuit board is faulty. Contact your Sundance Spas dealer or qualified service technician.
